Adding iSCSI hangs
Posted: Tue Jan 19, 2010 2:28 pm
Hello
I just installed StarPort the first time on a Windows XP (32 Bit) and tried to add an iSCSI target from a new QNAP TS-639 Pro.
It finds the device over DNS name (in the hosts file) and also shows me the target i want connect to.
First tried to attach it with CHAP authentication, but always told me there was an error. Then, disabled authentication on the target and tried it again. Unfortunately it hangs without doing anything.
Someone knows about such a problem?
Thanks a lot
Urs
I just installed StarPort the first time on a Windows XP (32 Bit) and tried to add an iSCSI target from a new QNAP TS-639 Pro.
It finds the device over DNS name (in the hosts file) and also shows me the target i want connect to.
First tried to attach it with CHAP authentication, but always told me there was an error. Then, disabled authentication on the target and tried it again. Unfortunately it hangs without doing anything.
Someone knows about such a problem?
Thanks a lot
Urs