StarWind Software

hi all,

i have two cluster nodes and one machine for iscsi target. on the cluster nodes is a initiator installed. All works correct, but when the target machine down or turned off then the cluster could not accses the resources, the cluster don't work more.

my question :

how can i creat high availbilty for iscsi target machine ?

is it possibel to set up one intiator to more than one iscsi targets?

regd,

almatador

Hi.

I think these guides will be useful for you:

http://www.rocketdivision.com/downloads ... or_HAV.pdf

http://www.rocketdivision.com/info/star ... luster.pdf

Hello Bohdan,

thank u for replying

i did read the manual about the HA iscsi target for MS cluster
in the manual configuration was discribed the configurations requriments:

two nodes and a shared disk resource.

where must be created first the shared disk resourse F:\? on the first node or on the second node.

in the manual is discribed that starwind will be referred to the F:\

it is assumed that befor configure the cluster, the shared disk F:\ must be configured on the first active node or on the second node?


regards,

almatador

The shared disk resource F is either hardware storage with two interfaces or iSCSI storage server configured with StarWind.