Page 1 of 1
Enable clustering on existing iscsi target?
Posted: Tue Apr 08, 2014 11:07 am
by haslund
Hello,
I have not been able to figure out how to enable iSCSI clustering if I forgot to enable it during creation of an iSCSI target.
Is this explained somewhere?
Thank you in advance.
Re: Enable clustering on existing iscsi target?
Posted: Tue Apr 08, 2014 11:47 am
by robnicholson
AFAIK you have to disconnect iSCSI targets, remove the target in StarWind and re-add. And yes, it's right pain if you've forgotten
In the latest StarWind, clustering is enabled by default so it's not as easy to forget.
Cheers, Rob.
Re: Enable clustering on existing iscsi target?
Posted: Wed Apr 09, 2014 9:33 am
by Anatoly (staff)
I`m totally agree with Rob.
Mr Nicholson, thank you for a perfect answer!
Re: Enable clustering on existing iscsi target?
Posted: Wed Apr 09, 2014 2:43 pm
by haslund
Thank you for the reply.
To me this should be possible to change from the GUI.
Re: Enable clustering on existing iscsi target?
Posted: Thu Apr 10, 2014 12:12 pm
by Anatoly (staff)
We already too it into the consideration. Thank you for the feedback!