Add existing device to target
Posted: Tue Apr 08, 2014 11:09 am
Hello,
When creating devices I was careful to give them useful/relevant names like shared-lun0.img.
However when adding existing device to a target I do not see these filenames anywhere, just ImageFile4 fx.
AFTER adding the device I can see the file, but that is a pain if you are not sure which ImageFileX is which XXX.img file.
Is there any way to enable that info in a column or something like that?
Thank you in advance.
When creating devices I was careful to give them useful/relevant names like shared-lun0.img.
However when adding existing device to a target I do not see these filenames anywhere, just ImageFile4 fx.
AFTER adding the device I can see the file, but that is a pain if you are not sure which ImageFileX is which XXX.img file.
Is there any way to enable that info in a column or something like that?
Thank you in advance.