Unable to start synchronisation

[robnicholson]

I'm not using the "Create cluster wizard" because I need to put the disk images on a different drive. The basic steps I'm doing is:

1. Create 1GB storage on SAN1 SSD via "Create device (advanced)" but leave target unassigned
2. Create 1GB storage on SAN2 SSD via "Create device (advanced)" but leave target unassigned
3. Right-click on the orphaned device and open replication manager
4. Go through the process of setting up the replica

Error message as shown attached occurs at the end but the mirror does appear to have been configured:

http://www.picpaste.com/sshot-10-Tezf6jmO.png

A manual start of sync works. Will try to repeat.

Cheers, Rob.

PS. Don't appear to be able to upload attachments today hence the picpaste link.

[robnicholson]

Yes this is repeatable. Just gone through the same steps. It actually occurs after this step:

http://www.picpaste.com/797f013e470cf01 ... 75ac1e.png

Cheers, Rob.

[anton (staff)]

Asked Alex and R&D guys to take a look. Thanks for reporting this out!